Conveyor chain tension is adjusted after the system has been completely stopped and all energy sources have been safely disconnected. The sag in the slack section of the chain is measured, both sides of the tensioning mechanism are advanced by equal amounts, and adequate operating clearance is left so the chain can move freely.
The basic procedure is as follows:
-
Stop the conveyor line in an unloaded condition.
-
Shut off electrical power and all other energy sources.
-
Prevent the system from being restarted.
-
Inspect the chain, sprockets and guides.
-
Measure the free sag of the chain.
-
Adjust the right and left tensioning points equally.
-
Check shaft and sprocket alignment.
-
Perform a test run after closing the guards.
A conveyor chain should never be fully taut. The chain needs a controlled operating clearance so it can adapt to the load variations that occur during motion.